Routine Inspection
Sep 15, 2026
6 recorded violations
Official wording
A PLUMBING SYSTEM shall be: (A) Repaired according to LAW; (P) and (B) Maintained in good repair.
In plain English
The business had issues with hot or cold running water, plumbing, drains, backflow prevention, or sewage disposal. Some of these, like no hot water, can force a temporary closure until fixed.
More about water, plumbing, or sewage problemsOfficial wording
EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements of the code.
In plain English
Equipment, utensils, thermometers, cutting boards, or single-use items were not in good condition, not the right type, or not stored properly.
More about equipment or utensil issuesOfficial wording
Concentration of the SANITIZING solution shall be accurately determined by using a test kit or other device. (Pf)
In plain English
Dishes, equipment, or surfaces that touch food were not properly washed, rinsed, and sanitized, or sanitizer was not at the right strength. Clean surfaces help stop germs from spreading to food.
More about cleaning or sanitizing problemsOfficial wording
(A) Equipment FOOD-CONTACT SURFACES and UTENSILS shall be cleaned: (1) Except as specified in ¶ (B) of this section, before each use with a different type of raw animal FOOD such as beef, FISH, lamb, pork, or POULTRY; (P) (2) Each time there is a change from working with raw FOODS to working with READY-TO-EAT FOODS; (P) (3) Between uses with raw fruits and vegetables and with POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD); (P) (4) Before using or storing a FOOD TEMPERATURE MEASURING DEVICE; (P) and (5) At any time during the operation when contamination may have occurred. (P) (B) Subparagraph (A)(1) of this section does not apply if the FOOD-CONTACT SURFACE or UTENSIL is in contact with a succession of different raw animal FOODS each requiring a higher cooking temperature as specified under § 3-401.11 than the previous FOOD, such as preparing raw FISH followed by cutting raw poultry on the same cutting board. (C) Except as specified in ¶ (D) of this section, if used with POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD), EQUIPMENT FOOD-CONTACT SURFACES and UTENSILS shall be cleaned throughout the day at least every 4 hours. (P) (D) Except when dry cleaning methods are used as specified under § 4-603.11, surfaces of UTENSILS and EQUIPMENT contacting FOOD that is not POTENTIALLY HAZARDOUS (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD) shall be cleaned: (1) At any time when contamination may have occurred; (2) At least every 24 hours for iced tea dispensers and CONSUMER self-service UTENSILS such as tongs, scoops, or ladles; (3) Before restocking CONSUMER self-service EQUIPMENT and UTENSILS such as condiment dispensers and display containers; and (4) In EQUIPMENT such as ice bins and BEVERAGE dispensing nozzles and enclosed components of EQUIPMENT such as ice makers, cooking oil storage tanks and distribution lines, BEVERAGE and syrup dispensing lines or tubes, coffee bean grinders, and water vending EQUIPMENT: (a) At a frequency
Inspector’s notes
Not cleaned
In plain English
Food was not kept cold enough, hot enough, cooled fast enough, or cooked or reheated to the right temperature. Bacteria grow quickly in the "danger zone" between 41°F and 135°F, which makes this one of the most important food-safety checks.
More about food kept at an unsafe temperatureOfficial wording
(A) In a mechanically refrigerated or hot FOOD storage unit, the sensor of a TEMPERATURE MEASURING DEVICE shall be located to measure the air temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot FOOD storage unit. (B) Cold or hot holding EQUIPMENT used for POTENTIALLY HAZARDOUS FOOD shall be designed to include and shall be equipped with at least one integral or permanently affixed TEMPERATURE MEASURING DEVICE that is located to allow easy viewing of the device's temperature display (EXCEPT, heat lamps, cold plates, steam tables, or other equipment where it is not practical). (C) TEMPERATURE MEASURING DEVICES shall be designed to be easily readable. (D) FOOD TEMPERATURE MEASURING DEVICES and water TEMPERATURE MEASURING DEVICES on WAREWASHING machines shall have a numerical scale, printed record, or digital readout in increments no greater than 1C or 2F in the intended range of use. (Pf)
In plain English
Food was not kept cold enough, hot enough, cooled fast enough, or cooked or reheated to the right temperature. Bacteria grow quickly in the "danger zone" between 41°F and 135°F, which makes this one of the most important food-safety checks.
More about food kept at an unsafe temperatureOfficial wording
A chemical SANITIZER used in a SANITIZING solution for a manual or mechanical operation shall meet these limits or as otherwise approved: (P) Chlorine ppm pH<10 pH<8 25 120 F 120 F 50 100 F 75 F 100 55 F 55 F Iodine a concentration of between 12.5 and 25 ppm and minimum temp of 75 F and pH of 5 or less or meets manufacturer's specifications. (P) Quats minimum temperature of 75 F, hardness of 500 ppm or less and meet manufacturers use directions. (P)
In plain English
Cleaning products, pesticides, or other chemicals were stored or labeled in a way that could let them get into food. This is serious because chemical contamination can make people sick quickly.
More about chemicals stored or used unsafelyOfficial record from Detroit Health Department, Sep 15, 2026 · Original Source