More issues recentlyThe latest inspection recorded more violations than the one before it. Review the dated records below.
The full inspection history
4 inspections
Routine Inspection
May 7, 2026
In compliance
2 recorded violations
minorCode 6-202.15Pests
Official wording
Outer openings of a FOOD ESTABLISHMENT shall be protected against the entry of insects and rodents. Unless otherwise allowed by law.
Inspector’s notes
Not sealed to prevent pest entry
In plain English
The inspector found mice, rats, cockroaches, flies, or evidence of them (like droppings) inside the business, or conditions that could attract them. Pests can spread bacteria to food and surfaces, so this is treated as one of the more serious findings.
Each HANDWASHING SINK or group of 2 adjacent HANDWASHING SINKS shall be provided with a supply of hand cleaning liquid, powder, or bar soap. (Pf)
In plain English
Staff were not washing their hands when required, or a handwashing sink was blocked, missing soap or paper towels, or used for something else. Hands are one of the most common ways germs reach food.
Official record from Detroit Health Department, May 7, 2026 · Original Source
Routine Inspection
Oct 10, 2025
Not in compliance
1 recorded violation
minorCode 4-602.11Food temperature
Official wording
(A) Equipment FOOD-CONTACT SURFACES and UTENSILS shall be cleaned: (1) Except as specified in ¶ (B) of this section, before each use with a different type of raw animal FOOD such as beef, FISH, lamb, pork, or POULTRY; (P) (2) Each time there is a change from working with raw FOODS to working with READY-TO-EAT FOODS; (P) (3) Between uses with raw fruits and vegetables and with POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD); (P) (4) Before using or storing a FOOD TEMPERATURE MEASURING DEVICE; (P) and (5) At any time during the operation when contamination may have occurred. (P) (B) Subparagraph (A)(1) of this section does not apply if the FOOD-CONTACT SURFACE or UTENSIL is in contact with a succession of different raw animal FOODS each requiring a higher cooking temperature as specified under § 3-401.11 than the previous FOOD, such as preparing raw FISH followed by cutting raw poultry on the same cutting board. (C) Except as specified in ¶ (D) of this section, if used with POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD), EQUIPMENT FOOD-CONTACT SURFACES and UTENSILS shall be cleaned throughout the day at least every 4 hours. (P) (D) Except when dry cleaning methods are used as specified under § 4-603.11, surfaces of UTENSILS and EQUIPMENT contacting FOOD that is not POTENTIALLY HAZARDOUS (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD) shall be cleaned: (1) At any time when contamination may have occurred; (2) At least every 24 hours for iced tea dispensers and CONSUMER self-service UTENSILS such as tongs, scoops, or ladles; (3) Before restocking CONSUMER self-service EQUIPMENT and UTENSILS such as condiment dispensers and display containers; and (4) In EQUIPMENT such as ice bins and BEVERAGE dispensing nozzles and enclosed components of EQUIPMENT such as ice makers, cooking oil storage tanks and distribution lines, BEVERAGE and syrup dispensing lines or tubes, coffee bean grinders, and water vending EQUIPMENT: (a) At a frequency specified by the manufacturer, or (b) Absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold.
In plain English
Food was not kept cold enough, hot enough, cooled fast enough, or cooked or reheated to the right temperature. Bacteria grow quickly in the "danger zone" between 41°F and 135°F, which makes this one of the most important food-safety checks.
Official record from Detroit Health Department, Oct 10, 2025 · Original Source
Routine Inspection
Jan 25, 2025
Not in compliance
4 recorded violations
majorCode 6-301.12Handwashing
Official wording
Each HANDWASHING SINK or group of adjacent HANDWASHING SINKS shall be provided with: (A) Individual, disposable towels; (Pf) (B) A continuous towel system that supplies the user with a clean towel;(Pf) or (C) A heated-air hand drying device.(Pf) (D) A hand drying device that employs an air-knife system that delivers high velocity pressurized air at ambient temperatures.(Pf)
In plain English
Staff were not washing their hands when required, or a handwashing sink was blocked, missing soap or paper towels, or used for something else. Hands are one of the most common ways germs reach food.
A chemical SANITIZER used in a SANITIZING solution for a manual or mechanical operation shall meet these limits or as otherwise approved: (P) Chlorine ppm pH<10 pH<8 25 120 F 120 F 50 100 F 75 F 100 55 F 55 F Iodine a concentration of between 12.5 and 25 ppm and minimum temp of 75 F and pH of 5 or less or meets manufacturer's specifications. (P) Quats minimum temperature of 75 F, hardness of 500 ppm or less and meet manufacturers use directions. (P)
In plain English
Cleaning products, pesticides, or other chemicals were stored or labeled in a way that could let them get into food. This is serious because chemical contamination can make people sick quickly.
(A) Equipment FOOD-CONTACT SURFACES and UTENSILS shall be cleaned: (1) Except as specified in ¶ (B) of this section, before each use with a different type of raw animal FOOD such as beef, FISH, lamb, pork, or POULTRY; (P) (2) Each time there is a change from working with raw FOODS to working with READY-TO-EAT FOODS; (P) (3) Between uses with raw fruits and vegetables and with POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD); (P) (4) Before using or storing a FOOD TEMPERATURE MEASURING DEVICE; (P) and (5) At any time during the operation when contamination may have occurred. (P) (B) Subparagraph (A)(1) of this section does not apply if the FOOD-CONTACT SURFACE or UTENSIL is in contact with a succession of different raw animal FOODS each requiring a higher cooking temperature as specified under § 3-401.11 than the previous FOOD, such as preparing raw FISH followed by cutting raw poultry on the same cutting board. (C) Except as specified in ¶ (D) of this section, if used with POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD), EQUIPMENT FOOD-CONTACT SURFACES and UTENSILS shall be cleaned throughout the day at least every 4 hours. (P) (D) Except when dry cleaning methods are used as specified under § 4-603.11, surfaces of UTENSILS and EQUIPMENT contacting FOOD that is not POTENTIALLY HAZARDOUS (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD) shall be cleaned: (1) At any time when contamination may have occurred; (2) At least every 24 hours for iced tea dispensers and CONSUMER self-service UTENSILS such as tongs, scoops, or ladles; (3) Before restocking CONSUMER self-service EQUIPMENT and UTENSILS such as condiment dispensers and display containers; and (4) In EQUIPMENT such as ice bins and BEVERAGE dispensing nozzles and enclosed components of EQUIPMENT such as ice makers, cooking oil storage tanks and distribution lines, BEVERAGE and syrup dispensing lines or tubes, coffee bean grinders, and water vending EQUIPMENT: (a) At a frequency specified by the manufacturer, or (b) Absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold.
In plain English
Food was not kept cold enough, hot enough, cooled fast enough, or cooked or reheated to the right temperature. Bacteria grow quickly in the "danger zone" between 41°F and 135°F, which makes this one of the most important food-safety checks.
Each HANDWASHING SINK or group of 2 adjacent HANDWASHING SINKS shall be provided with a supply of hand cleaning liquid, powder, or bar soap. (Pf)
In plain English
Staff were not washing their hands when required, or a handwashing sink was blocked, missing soap or paper towels, or used for something else. Hands are one of the most common ways germs reach food.
Official record from Detroit Health Department, Jan 25, 2025 · Original Source
Routine Inspection
Feb 23, 2024
Not in compliance
3 recorded violations
majorCode 6-501.111Pests
Official wording
The presence of insects, rodents, and other pests shall be controlled to minimize their presence on the PREMISES. by: (A) Routinely inspecting incoming shipments of FOOD and supplies; (B) Routinely inspecting the PREMISES for evidence of pests; (C) Using methods, if pests are found, such as trapping devices or other means of pest control as specified.(Pf) (D) Eliminating harborage conditions.
Inspector’s notes
Present in facility
In plain English
The inspector found mice, rats, cockroaches, flies, or evidence of them (like droppings) inside the business, or conditions that could attract them. Pests can spread bacteria to food and surfaces, so this is treated as one of the more serious findings.
Multiuse FOOD-CONTACT SURFACES shall be: SMOOTH, be easily cleaned, free of breaks, chips, pits, etc and easily accessible for cleaning and inspection. (Pf)
Inspector’s notes
Not easily cleanable
In plain English
Dishes, equipment, or surfaces that touch food were not properly washed, rinsed, and sanitized, or sanitizer was not at the right strength. Clean surfaces help stop germs from spreading to food.
An air gap between the water supply inlet and the flood level rim of the PLUMBING FIXTURE, EQUIPMENT, or nonFOOD EQUIPMENT shall be at least twice the diameter of the water supply inlet and may not be less than 1 inch. (P)
Inspector’s notes
Not provided
In plain English
The business had issues with hot or cold running water, plumbing, drains, backflow prevention, or sewage disposal. Some of these, like no hot water, can force a temporary closure until fixed.