SteadyThe last two inspections recorded a similar number of violations. Review the dated records below.
The full inspection history
4 inspections
Routine Inspection
May 28, 2026
In compliance
1 recorded violation
majorCode 6-301.11Handwashing
Official wording
Each HANDWASHING SINK or group of 2 adjacent HANDWASHING SINKS shall be provided with a supply of hand cleaning liquid, powder, or bar soap. (Pf)
Inspector’s notes
Not provided
In plain English
Staff were not washing their hands when required, or a handwashing sink was blocked, missing soap or paper towels, or used for something else. Hands are one of the most common ways germs reach food.
Official record from Detroit Health Department, May 28, 2026 · Original Source
Routine Inspection
Nov 3, 2025
In compliance
1 recorded violation
criticalCode 4-501.114Chemicals
Official wording
A chemical SANITIZER used in a SANITIZING solution for a manual or mechanical operation shall meet these limits or as otherwise approved: (P) Chlorine ppm pH<10 pH<8 25 120 F 120 F 50 100 F 75 F 100 55 F 55 F Iodine a concentration of between 12.5 and 25 ppm and minimum temp of 75 F and pH of 5 or less or meets manufacturer's specifications. (P) Quats minimum temperature of 75 F, hardness of 500 ppm or less and meet manufacturers use directions. (P)
Inspector’s notes
Below 100 ppm
In plain English
Cleaning products, pesticides, or other chemicals were stored or labeled in a way that could let them get into food. This is serious because chemical contamination can make people sick quickly.
Official record from Detroit Health Department, Nov 3, 2025 · Original Source
Routine Inspection
May 1, 2025
In compliance
1 recorded violation
majorCode 3-501.15Food temperature
Official wording
(A) Cooling shall be accomplished in accordance with the time and temperature criteria specified under § 3-501.14 by using one or more of the following methods based on the type of FOOD being cooled: (1) Placing the FOOD in shallow pans; (Pf) (2) Separating the FOOD into smaller or thinner portions; (Pf) (3) Using rapid cooling EQUIPMENT; (Pf) (4) Stirring the FOOD in a container placed in an ice water bath; (Pf) (5) Using containers that facilitate heat transfer; (Pf) (6) Adding ice as an ingredient; (Pf) or (7) Other effective methods. (Pf) (B) When placed in cooling or cold holding EQUIPMENT, FOOD containers in which FOOD is being cooled shall be: (1) Arranged in the EQUIPMENT to provide maximum heat transfer through the container walls; and (2) Loosely covered, or uncovered if protected from overhead contamination as specified under Subparagraph 3-305.11(A)(2), during the cooling period to facilitate heat transfer from the surface of the FOOD.
Inspector’s notes
Improperly
In plain English
Food was not kept cold enough, hot enough, cooled fast enough, or cooked or reheated to the right temperature. Bacteria grow quickly in the "danger zone" between 41°F and 135°F, which makes this one of the most important food-safety checks.
Official record from Detroit Health Department, May 1, 2025 · Original Source
Routine Inspection
Sep 13, 2024
Not in compliance
2 recorded violations
criticalCode 5-402.11Water, plumbing, and sewage
Official wording
Except as otherwise allowed, a direct connection may not exist between the SEWAGE system and a drain originating from EQUIPMENT in which FOOD, portable EQUIPMENT, or UTENSILS are placed. (P)
Inspector’s notes
Unorganized
In plain English
The business had issues with hot or cold running water, plumbing, drains, backflow prevention, or sewage disposal. Some of these, like no hot water, can force a temporary closure until fixed.
(A) Equipment FOOD-CONTACT SURFACES and UTENSILS shall be cleaned: (1) Except as specified in ¶ (B) of this section, before each use with a different type of raw animal FOOD such as beef, FISH, lamb, pork, or POULTRY; (P) (2) Each time there is a change from working with raw FOODS to working with READY-TO-EAT FOODS; (P) (3) Between uses with raw fruits and vegetables and with POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD); (P) (4) Before using or storing a FOOD TEMPERATURE MEASURING DEVICE; (P) and (5) At any time during the operation when contamination may have occurred. (P) (B) Subparagraph (A)(1) of this section does not apply if the FOOD-CONTACT SURFACE or UTENSIL is in contact with a succession of different raw animal FOODS each requiring a higher cooking temperature as specified under § 3-401.11 than the previous FOOD, such as preparing raw FISH followed by cutting raw poultry on the same cutting board. (C) Except as specified in ¶ (D) of this section, if used with POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD), EQUIPMENT FOOD-CONTACT SURFACES and UTENSILS shall be cleaned throughout the day at least every 4 hours. (P) (D) Except when dry cleaning methods are used as specified under § 4-603.11, surfaces of UTENSILS and EQUIPMENT contacting FOOD that is not POTENTIALLY HAZARDOUS (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD) shall be cleaned: (1) At any time when contamination may have occurred; (2) At least every 24 hours for iced tea dispensers and CONSUMER self-service UTENSILS such as tongs, scoops, or ladles; (3) Before restocking CONSUMER self-service EQUIPMENT and UTENSILS such as condiment dispensers and display containers; and (4) In EQUIPMENT such as ice bins and BEVERAGE dispensing nozzles and enclosed components of EQUIPMENT such as ice makers, cooking oil storage tanks and distribution lines, BEVERAGE and syrup dispensing lines or tubes, coffee bean grinders, and water vending EQUIPMENT: (a) At a frequency specified by the manufacturer, or (b) Absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold.
Inspector’s notes
Not cleaned
In plain English
Food was not kept cold enough, hot enough, cooled fast enough, or cooked or reheated to the right temperature. Bacteria grow quickly in the "danger zone" between 41°F and 135°F, which makes this one of the most important food-safety checks.