ImprovingThe latest inspection recorded fewer violations than the one before it. Review the dated records below.
The full inspection history
6 inspections
Complaint
Apr 28, 2026
In compliance
1 recorded violation
majorCode 5-205.11Handwashing
Official wording
(A) A HANDWASHING SINK shall be maintained so that it is accessible at all times for EMPLOYEE use and used for no other purpose. (Pf) (B) An automatic handwashing facility shall be used in accordance with manufacturer's instructions. (Pf)
In plain English
Staff were not washing their hands when required, or a handwashing sink was blocked, missing soap or paper towels, or used for something else. Hands are one of the most common ways germs reach food.
Official record from Detroit Health Department, Apr 28, 2026 · Original Source
Routine Inspection
Mar 3, 2026
Not in compliance
5 recorded violations
minorCode 4-602.13Cleaning and sanitizing
Official wording
NonFOOD-CONTACT SURFACES of EQUIPMENT shall be cleaned at a frequency necessary to preclude accumulation of soil residues.
Inspector’s notes
With accumulation of debris
In plain English
Dishes, equipment, or surfaces that touch food were not properly washed, rinsed, and sanitized, or sanitizer was not at the right strength. Clean surfaces help stop germs from spreading to food.
(A) Cooling shall be accomplished in accordance with the time and temperature criteria specified under § 3-501.14 by using one or more of the following methods based on the type of FOOD being cooled: (1) Placing the FOOD in shallow pans; (Pf) (2) Separating the FOOD into smaller or thinner portions; (Pf) (3) Using rapid cooling EQUIPMENT; (Pf) (4) Stirring the FOOD in a container placed in an ice water bath; (Pf) (5) Using containers that facilitate heat transfer; (Pf) (6) Adding ice as an ingredient; (Pf) or (7) Other effective methods. (Pf) (B) When placed in cooling or cold holding EQUIPMENT, FOOD containers in which FOOD is being cooled shall be: (1) Arranged in the EQUIPMENT to provide maximum heat transfer through the container walls; and (2) Loosely covered, or uncovered if protected from overhead contamination as specified under Subparagraph 3-305.11(A)(2), during the cooling period to facilitate heat transfer from the surface of the FOOD.
Inspector’s notes
Improperly
In plain English
Food was not kept cold enough, hot enough, cooled fast enough, or cooked or reheated to the right temperature. Bacteria grow quickly in the "danger zone" between 41°F and 135°F, which makes this one of the most important food-safety checks.
Each HANDWASHING SINK or group of adjacent HANDWASHING SINKS shall be provided with: (A) Individual, disposable towels; (Pf) (B) A continuous towel system that supplies the user with a clean towel;(Pf) or (C) A heated-air hand drying device.(Pf) (D) A hand drying device that employs an air-knife system that delivers high velocity pressurized air at ambient temperatures.(Pf)
Inspector’s notes
Not provided
In plain English
Staff were not washing their hands when required, or a handwashing sink was blocked, missing soap or paper towels, or used for something else. Hands are one of the most common ways germs reach food.
Except during preparation, cooking, or cooling, or when time is used as the public health control POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD) shall be maintained: (A) 135ºF or above, except that roasts properly cooked and cooled may be held at a temperature of 130ºF; or (P) (B) At 41ºF or less (P)
Inspector’s notes
Stored above 41 degrees F
In plain English
Food was not kept cold enough, hot enough, cooled fast enough, or cooked or reheated to the right temperature. Bacteria grow quickly in the "danger zone" between 41°F and 135°F, which makes this one of the most important food-safety checks.
A test kit or other device that accurately measures the concentration in mg/L of SANITIZING solutions shall be provided. (Pf)
Inspector’s notes
Not provided
In plain English
Dishes, equipment, or surfaces that touch food were not properly washed, rinsed, and sanitized, or sanitizer was not at the right strength. Clean surfaces help stop germs from spreading to food.
Cleaned EQUIPMENT and UTENSILS, laundered LINENS, and SINGLE-SERVICE and SINGLE-USE ARTICLES shall be stored in an approved manner and location.
Inspector’s notes
Stored on floor or less than 6 inches above floor
In plain English
Dishes, equipment, or surfaces that touch food were not properly washed, rinsed, and sanitized, or sanitizer was not at the right strength. Clean surfaces help stop germs from spreading to food.
Except during preparation, cooking, or cooling, or when time is used as the public health control POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD) shall be maintained: (A) 135ºF or above, except that roasts properly cooked and cooled may be held at a temperature of 130ºF; or (P) (B) At 41ºF or less (P)
Inspector’s notes
Stored above 41 degrees F
In plain English
Food was not kept cold enough, hot enough, cooled fast enough, or cooked or reheated to the right temperature. Bacteria grow quickly in the "danger zone" between 41°F and 135°F, which makes this one of the most important food-safety checks.
A test kit or other device that accurately measures the concentration in mg/L of SANITIZING solutions shall be provided. (Pf)
Inspector’s notes
Not provided
In plain English
Dishes, equipment, or surfaces that touch food were not properly washed, rinsed, and sanitized, or sanitizer was not at the right strength. Clean surfaces help stop germs from spreading to food.
A chemical SANITIZER used in a SANITIZING solution for a manual or mechanical operation shall meet these limits or as otherwise approved: (P) Chlorine ppm pH<10 pH<8 25 120 F 120 F 50 100 F 75 F 100 55 F 55 F Iodine a concentration of between 12.5 and 25 ppm and minimum temp of 75 F and pH of 5 or less or meets manufacturer's specifications. (P) Quats minimum temperature of 75 F, hardness of 500 ppm or less and meet manufacturers use directions. (P)
In plain English
Cleaning products, pesticides, or other chemicals were stored or labeled in a way that could let them get into food. This is serious because chemical contamination can make people sick quickly.
Exhaust ventilation hood systems in FOOD preparation and WAREWASHING areas including components such as hoods, fans, guards, and ducting shall be designed to prevent grease or condensation from draining or dripping onto FOOD, EQUIPMENT, UTENSILS, LINENS, and SINGLE-SERVICE and SINGLE-USE ARTICLES.
Inspector’s notes
Designed to allow grease or condensation from draining/dripping onto
In plain English
The business had issues with hot or cold running water, plumbing, drains, backflow prevention, or sewage disposal. Some of these, like no hot water, can force a temporary closure until fixed.
During pauses in FOOD preparation or dispensing, UTENSILS shall be stored: (A) In the FOOD with their handles above the top of the FOOD and the container; (B) In FOOD that is not POTENTIALLY HAZARDOUS with their handles above the top of the FOOD within containers or EQUIPMENT that can be closed, such as bins of sugar, flour, or cinnamon; (C) On a clean portion of the FOOD preparation table or cooking EQUIPMENT (D) In running water, such as dipper well. (E) In a clean, protected location if the UTENSILS, such as ice scoops, are used only with a FOOD that is not POTENTIALLY HAZARDOUS; or (F) In a container of water maintained at a temperature of at least 135° F.
Inspector’s notes
Improperly stored
In plain English
Food was not kept cold enough, hot enough, cooled fast enough, or cooked or reheated to the right temperature. Bacteria grow quickly in the "danger zone" between 41°F and 135°F, which makes this one of the most important food-safety checks.
Official record from Detroit Health Department, Aug 20, 2025 · Original Source
Site Evaluation
Feb 5, 2025
In compliance
0 recorded violations
No violations recorded in this inspection.
Official record from Detroit Health Department, Feb 5, 2025 · Original Source
Site Evaluation
Jan 22, 2025
Not in compliance
2 recorded violations
criticalCode 5-202.13Water, plumbing, and sewage
Official wording
An air gap between the water supply inlet and the flood level rim of the PLUMBING FIXTURE, EQUIPMENT, or nonFOOD EQUIPMENT shall be at least twice the diameter of the water supply inlet and may not be less than 1 inch. (P)
Inspector’s notes
Not provided
In plain English
The business had issues with hot or cold running water, plumbing, drains, backflow prevention, or sewage disposal. Some of these, like no hot water, can force a temporary closure until fixed.