Routine Inspection
Jul 30, 2026
4 recorded violations
Official wording
NonFOOD-CONTACT SURFACES of EQUIPMENT shall be cleaned at a frequency necessary to preclude accumulation of soil residues.
Inspector’s notes
Soiled
In plain English
Dishes, equipment, or surfaces that touch food were not properly washed, rinsed, and sanitized, or sanitizer was not at the right strength. Clean surfaces help stop germs from spreading to food.
More about cleaning or sanitizing problemsOfficial wording
PHYSICAL FACILITIES shall be maintained in good repair.
Inspector’s notes
In poor repair
In plain English
Floors, walls, ceilings, lighting, ventilation, or garbage areas needed repair or cleaning. These are usually less urgent than food-handling problems but still need to be fixed.
More about building upkeep issuesOfficial wording
(A) Equipment FOOD-CONTACT SURFACES and UTENSILS shall be cleaned: (1) Except as specified in ¶ (B) of this section, before each use with a different type of raw animal FOOD such as beef, FISH, lamb, pork, or POULTRY; (P) (2) Each time there is a change from working with raw FOODS to working with READY-TO-EAT FOODS; (P) (3) Between uses with raw fruits and vegetables and with POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD); (P) (4) Before using or storing a FOOD TEMPERATURE MEASURING DEVICE; (P) and (5) At any time during the operation when contamination may have occurred. (P) (B) Subparagraph (A)(1) of this section does not apply if the FOOD-CONTACT SURFACE or UTENSIL is in contact with a succession of different raw animal FOODS each requiring a higher cooking temperature as specified under § 3-401.11 than the previous FOOD, such as preparing raw FISH followed by cutting raw poultry on the same cutting board. (C) Except as specified in ¶ (D) of this section, if used with POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD), EQUIPMENT FOOD-CONTACT SURFACES and UTENSILS shall be cleaned throughout the day at least every 4 hours. (P) (D) Except when dry cleaning methods are used as specified under § 4-603.11, surfaces of UTENSILS and EQUIPMENT contacting FOOD that is not POTENTIALLY HAZARDOUS (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD) shall be cleaned: (1) At any time when contamination may have occurred; (2) At least every 24 hours for iced tea dispensers and CONSUMER self-service UTENSILS such as tongs, scoops, or ladles; (3) Before restocking CONSUMER self-service EQUIPMENT and UTENSILS such as condiment dispensers and display containers; and (4) In EQUIPMENT such as ice bins and BEVERAGE dispensing nozzles and enclosed components of EQUIPMENT such as ice makers, cooking oil storage tanks and distribution lines, BEVERAGE and syrup dispensing lines or tubes, coffee bean grinders, and water vending EQUIPMENT: (a) At a frequency
Inspector’s notes
Not cleaned
In plain English
Food was not kept cold enough, hot enough, cooled fast enough, or cooked or reheated to the right temperature. Bacteria grow quickly in the "danger zone" between 41°F and 135°F, which makes this one of the most important food-safety checks.
More about food kept at an unsafe temperatureOfficial wording
The presence of insects, rodents, and other pests shall be controlled to minimize their presence on the PREMISES. by: (A) Routinely inspecting incoming shipments of FOOD and supplies; (B) Routinely inspecting the PREMISES for evidence of pests; (C) Using methods, if pests are found, such as trapping devices or other means of pest control as specified.(Pf) (D) Eliminating harborage conditions.
Inspector’s notes
Present in facility
In plain English
The inspector found mice, rats, cockroaches, flies, or evidence of them (like droppings) inside the business, or conditions that could attract them. Pests can spread bacteria to food and surfaces, so this is treated as one of the more serious findings.
More about signs of rodents or insectsOfficial record from Detroit Health Department, Jul 30, 2026 · Original Source